SecuraSpan® Horizontal Lifeline System
7400120 (20'system)(Additional Systems Below)
- SecuraSpan® system comes with everything needed and is installed with no special tools or equipment - No system "tie-back" is necessary!
- Lightweight stanchions incorporate a single clamp design with a simple wingnut that allows for fast attachment and easy adjustment
- Complete with two stanchions with built-in fastening system for quick and easy installation (intermediate stanchions available for multi-span systems)
- Bypassable design and unlimited system length provides 100% protection and flexibility
- Includes a Zorbit® energy absorber with turnbuckle for added safety and tensioning of the system
- Standard size fits flanges up to 12" wide, and 2-1/4" thick (optional base clamps available to fit 18", 24" or 36" wide beams)
- System length = 20 ft. cable assembly with fastening hardware (30, 40, 50 and 60 ft. systems are also available)
- Meets or exceeds all applicable industry standards including OSHA and ANSI.
A Safe Solution to Non-Engineered Systems
The SecuraSpan horizontal lifeline (HLL) system was developed to provide an economical and safe solution to non-engineered homemade HLL systems. The system and all components have been rigorously tested to exceed the unique dynamic, performance and strength requirements involved with horizontal systems. The extremely lightweight stanchions can be configured into a complete engineered fall protection system for steel erectors.
Provides Complete Jobsite Flexibility
With the optional "bypass" bracket, the system can be configured to run indefinitely for ultimate jobsite flexibility. Spans between intermediates can be as great as 60 ft. depending upon your clearance requirements. The standard SecuraSpan stanchion fits beam flange widths up to 12 inches in width and up to 2-1/4 inches thick. Optional base clamps are available to fit flange widths up to 18 inches, 24 inches and 36 inches for the ultimate in system adjustability.
Installation is simple, fast and efficient with a single clamp anchor on the stanchions base. Utilizing the clamp's hook, you simply slide it snug to the beam flange and tighten the wingnut and your done. The unique high strength design does not require tedious tie-back anchoring saving you time and reducing trip fall hazards. Total installation is 50% quicker than competitive systems which often require two clamp assemblies and tie-back anchoring. A worker can move the temporary system from one location to another for added productivity.
Customize Your Own System: